Posts Tagged french press
Everybody loves a guessing game don’t they? I hope so as I’m looking for some enlightenment today.
So it was with this object I found the other day (although it wasn’t particularly cheap) and I don’t know what it is. Can anybody help?
I know it is some sort of press but I can’t think for what.
I know it’s not a press for vintage soda siphons but it was the nearest thing on hand to prop the bar up with. The slider bar moves up and down the grooved interior and the screw can push the bar down to a maxium of 25cm or 10 inches leaving a final squishing space of 23cm or 9 inches.
The nearest thing to it I have found on the internet is a press for playing cards. Apparently, it was used by dealers in casinos when the decks of cards got a bit scrunched and the press would be used to straighten them out. However, it was much smaller than this one and there were dividers in between the bar and the end so each card could slot in individually.
This one measures 56cm or 21.5 inches in length and 18cm or 7 inches wide. It is 5cm or 2 inches deep. The interior width, inside the grooves where the object(s) would need to sit, is 12.6cm or 5 inches.
It is very well made and was obviously well used. Somebody has seen fit to repair or reinforce the top corners at one time with metal but this has also been done well.
Any comments, ideas, suggestions or, even better, answers would be greatly appreciated.